Product Description
A2 Stainless Steel Conical Seat Washers – DIN 6319 Type D
These A2 stainless steel conical seat washers conform to DIN 6319 Type D and are designed for use with matching DIN 6319 Type C spherical washers. Together, the two components accommodate small angular differences between a bolt or stud and its supporting surface, helping the fastener seat correctly in clamping assemblies.
The matched washer and seat combination allows approximately 3° of angular adjustment in any direction. Available nominal sizes are M6, M8, M10 and M12.
Specifications
| Product type | Conical seat washer |
|---|---|
| Standard | DIN 6319, Type D |
| Material | A2 stainless steel |
| Nominal sizes | M6, M8, M10 and M12 |
| Matching component | DIN 6319 Type C spherical washer of the corresponding nominal size |
| Angular adjustment | Approximately 3° in any direction when used with a matching Type C spherical washer |
Dimensions
| Nominal Bolt Size | Bore Diameter | Outside Diameter | Seat Height |
|---|---|---|---|
| M6 | 7.1mm | 12mm | 2.8mm |
| M8 | 9.6mm | 17mm | 3.5mm |
| M10 | 12mm | 21mm | 4.2mm |
| M12 | 14.2mm | 24mm | 5mm |
Dimensions are nominal and shown in millimetres. Seat height refers to the Type D component alone, excluding the matching spherical washer. M sizes identify the nominal bolt size, not the actual bore diameter.
Key Features
- A2 stainless steel construction for corrosion resistance.
- DIN 6319 Type D conical seating profile.
- Pairs with a corresponding Type C spherical washer for angular alignment.
- Four nominal sizes covering M6 to M12 fasteners.
- Suitable for fixtures, tooling and clamping assemblies.
Typical Applications
Used in machine fixtures, jigs, maintenance equipment and bolted clamping arrangements where small angular differences need to be accommodated at the fastener seating surface.
Installation
Position the flat underside of the Type D seat against a suitable supporting surface, with the conical recess facing the matching Type C washer. Fit the convex spherical face of the Type C washer into the recess, leaving its flat face against the nut or bolt head. Ensure both components are the same nominal size and correctly seated before tightening.
Ordering
Select the required nominal size and pack quantity from the available options. This listing is for the Type D conical seat component; order the matching Type C spherical washer separately where required.
Standards
DIN 6319 Type D – conical seats for use with corresponding DIN 6319 Type C spherical washers.
